Preparing A Wireless Station; Starting The Nokia A032 In Learn Mode - Nokia A032 Getting Started Manual

Wireless lan access point
Hide thumbs Also See for A032:
Table of Contents

Advertisement

Preparing a wireless station

If your wireless station
uses the Nokia C110
Wireless LAN Card and
drivers, the default
settings of the driver
when first installed
will be correct to
access the Nokia A032.

Starting the Nokia A032 in Learn mode

mode button
Setting up and testing
You use the wireless station to configure and
test the Nokia A032:
1
If you use a third-party wireless LAN card,
or your Nokia driver does not have default
settings, reconfigure your wireless station
with the following parameters:
Mode:
Infrastructure
Network Name:
(please see the manual that came with your
wireless LAN card for instructions).
2
Ensure that any WEP security measures are
switched off (please see the manual that
came with your wireless station for
instructions).
3
Shut down the wireless station.
Learn mode allows you to configure the Nokia
A032 from its default (factory) state.
1
Remove the power connector from the rear
panel of the Nokia A032, or switch off the
power at the wall outlet.
2
Press and hold the
still holding it, power the unit on again.
Continue to hold the
LEDs all switch on, then go off. This
info
takes about three seconds.
3
Release the
mode
display a 'chasing' pattern, with one LED
moving rapidly from right to left.
Nokia WLAN
button and, while
mode
button while the
mode
button. The
info
LEDs
19

Advertisement

Table of Contents
loading

Table of Contents