Console Overview - BLADEZ Stratum GS Owner's Manual

BATTERIES INSTALLATION
Please install 1 AAA 1.5V battery in the battery case on the back of monitor. The display will
light up 1 for second, then the scan function will value form Time. (Whenever Batteries are
removed, all the functions values will be reset to zero.)
BUTTON
A: Mode: Press it to select the function value to display on the LCD.
Press it for two seconds, all function value will be reset to zero.
Press it for five seconds, can switch KM/Mile and all function value will reset to zero.
B: Select: Press it for three seconds, can switch speed (elliptical ) to count (stepper) in stop mode.
When the user selects the speed function for elliptical, the arrow point will point at
SPEED MODE until the the user switches it to COUNT MODE with the count
function.
AUTO ON/OFF
When the user begins exercise, the Display will show the workout value automatically. Once
exercising has stopped for more than 256 sec and no buttons have been pushed, the Display will
turn off. When the user begins the exercise again, or presses any button, the workout function
value with display again.
AUTO SCAN
After the display has been activated by pressing any button, the LCD will show all functions
values for the Elliptical exercise mode (Time, Calories, Speed, Distance). Each value will be held
for 6 seconds. If the user selects the COUNT MODE, the LCD will display all functions values
(Time, Calories, Counts).
COUNT
Displays the step from 0 to 9999.
TIME
Displays the workout time from 00:00 to 99:59. User can press the button until the ARROW
points to Time to display the workout time value.
CALORIES
Displays the calories consumption during training from 0.0 to 9999. User can press the button
until the ARROW points to display the calories consumption value.
SPEED

CONSOLE OVERVIEW

17