SECTION 3: ADJUSTMENTS
Headstock
The Model G1067Z headstock can be swiveled
180˚ as well as positioned anywhere along the
bed.
1.
Loosen the quick release lever by pushing it
down (Figure 13).
2.
Move the headstock to the desired position
and re-engage the quick release lever
(Figure 14). Note—The large hex nut under
the headstock will require occasional adjust-
ing to assure proper clamping pressure to
the bed. Turn the hex nut in small increments
to fine tune the clamping pressure.
Quick release lever
Figure 13.
-14-
Figure 14.
1.
Loosen the quick release lever by pushing it
down.
2.
Pull the spring loaded quick release set pin
(Figure 15) and rotate the headstock clock-
wise 90˚ or 180˚.
Figure 15.
Set pin
G1067Z Wood Lathe