Pulse Mode - Jenn-Air Attrezzi JBL800 User Manual

Turning the Blender Off
While the blender is operating, touch the "OFF" pad on the control
panel or touch the active speed setting pad a second time and the
blender will stop. The "ON" pad will still be illuminated and the
WARNING light will flash to indicate the blender is ready to operate
again. Press the "OFF" pad a second time to completely turn the
blender off.
Auto Shut-off
• The blender will automatically shut off if allowed to stand with no
control pads pressed for 10 minutes.
• If two speed settings pads are accidentally touched at the same
time, the blender will shut off. Select desired speed setting pad to
start or restart.

Pulse Mode

1. Touch the "ON" pad on the control panel. The "ON" pad will
illuminate and the WARNING light will flash to indicate that the
blender is ready to operate.
2. Touch the "PULSE" pad.
3. Select a speed setting and touch the corresponding pad on the
control panel.
4. The blender will operate only while you are touching the speed
setting pad.
Note
• When unsure about the appropriate speed setting, try pulsing to
test various speeds.
7