Operating Your Blender - Jenn-Air Attrezzi JBL800 User Manual

Removing pitcher from base
1. Make sure the blender controls are set to
"OFF" and the power cord is unplugged.
2. Turn the pitcher counterclockwise and lift
the pitcher up and off the base.
3. Do not unscrew the base ring from the
pitcher jar until you are ready to remove
the blade assembly. Loosening it will
cause leaking.
Note
• Be sure to operate your blender on a clean, dry, sturdy surface.

Operating Your Blender

1. Make sure the touch controls are SET TO "OFF" and the power
cord is unplugged.
2. Place the assembled PITCHER ON TOP OF BLENDER BASE and
turn clockwise to lock the pitcher in place.
3. LOAD BLENDER with food to be blended and
place the lid securely on the pitcher jar.
4. TOUCH THE "ON" PAD on the control panel.
The "ON" pad should illuminate and the
WARNING light will flash to indicate that the
blender is ready to operate.
5. TOUCH ONE OF THE 5-SPEED PADS. Refer to the "Speed
Control Guide" in this manual for suggested settings. Refer to
the "Pulse Mode" and "Ice Crushing Mode" sections in this
manual for use of those controls.
To avoid risk of injury, be sure that the blender is fully off with
all control panel lights off before opening the blender and
scraping the sides of the pitcher. Never attempt to scrape the
sides of the pitcher while the blender is operating or with any of
the control panel lights illuminated.
WARNING
6
OFF
ON
MIX
CRUSH PULSE