Table of Contents
Advertisement
2) install the gasket 1 (supplied in the boiler's supply package) (see Scheme 9);
Scheme 9. Gasket installation
3)
Make sure that the seal ring 6 is placed (at the place of connection of the fan plug) before installing the separator onto the boiler (see Scheme 10);
Install the channel separator 2 onto the boiler, controlling that the plug won't "bite on" the seal ring 6;
4)
Fix the channel separator by four screws 3 (previously install the plain washer 4, and then the ring 5 on each screw);
5)
Make sure that there are seal rings 7 (2 pcs.) placed on the inlet and outlet of the channel separator before further installation of the smoke exhauster and air circuit
6)
pipes
The installation of the air inlet pipe and the smoke exhauster pipe must be effectuated in accordance with Scheme 7 (see p.9.2, page 18).
7)
Scheme 8. Duct slice dismantling
Technical staff manual
Advertisement
Table of Contents
