Dvd/Video Cd; Playing A Disc; To Display The Dvd Mode Screen - Alpine INA-W910 Owner's Manual

DVD/Video CD

Display example for DVD Video main screen
Displays the disc (DVD VIDEO, DVD AUDIO, VIDEO
CD) being played back.
Displays the elapsed playback time.
• Some operations cannot be carried out depending on the disc or
playback screen.
• Displays of the function guide [P1/2], etc. may vary depending on the
connected device(s).
Changes the Contrast Level adjustment screen directly.
For details, refer to "Adjusting Image Brilliance (Live
Contrast)" on page 62.
Disc types that can be used for each heading are
represented by the following marks.
DVD Commercial Video discs (used for the
distribution of movies, etc.) or a DVD-R/
DVD-RW, DVD+R/DVD+RW recorded in a
video mode can be used.
DVD Commercial Audio discs can be used.
Video-CD discs can be used.

Playing a Disc

INA-W910 has a built-in DVD player. When an optional Alpine DVD/
Video CD/CD player (or DVD changer) is connected to the INA-W910,
you can control it from the INA-W910 (except some operations).
WARNING
It is dangerous (and illegal in many states) for the
driver to watch the DVD/TV/Video while driving the
vehicle. The driver may be distracted from looking
ahead and an accident could occur.
Install the INA-W910 correctly so that the driver
cannot watch DVD/TV/Video unless the vehicle is
stopped and the emergency brake is applied.
If the INA-W910 is not installed correctly, the driver
will be able to watch the DVD/TV/Video while driving
the vehicle and may be distracted from looking ahead
causing an accident. The driver or other people could
be severely injured.

To display the DVD mode screen

To watch a video source, your vehicle must be parked with the ignition
key in the ACC or ON position. To do this, follow the procedures below.
1 Push the foot brake to bring your vehicle to a complete
stop at a safe location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 While the parking brake is being engaged the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever in
the Park position.
Now, the locking system for the DVD mode operation has been
released. Engaging the parking brake can reactivate the DVD mode, as
long as the car's ignition has not been turned off. It is not necessary to
repeat the above procedure (1 through 3), of "To display the DVD mode
screen."
Each time the ignition is turned OFF, perform the procedure of "To
display the DVD mode screen."
• If you try to activate the auxiliary device while driving, the display
will show the warning-Picture off for your safety.
Caution
• Not all functions will operate for every DVD. See the
individual DVD's instructions for details on the
features supported.
• Fingerprints on a disc may adversely affect
playback. If a problem occurs, remove the disc and
check for fingerprints on the playback side. Clean
the disc if necessary.
• If you switch the power or Ignition key OFF or change
sources during playback, playback will continue
where you left off when you resume playback.
• If you try to perform an invalid operation (based on
the type of disc being played), the following mark is
displayed on the monitor screen:
• Play Position Memory Function
Even if you turn power off or switch the Ignition key
to OFF during playback or change the source,
playback will continue from the point where
playback stopped when the power is turned ON
again.
.
45
-EN