Table of Contents
Advertisement
SIRD-FTA-2
3. Channel Lock: If set to "Yes", you need to enter the password before you
can see those channels which have been marked as locked channels in
the channel menu. If set to "No", those channels can be selected without
entering the password first.
4. New Password: Here you can change the existing password. You should
do this after you set up the receiver the first time and every time you
think your password is known by unauthorized persons. To change the
password, enter the new password in the "New Password", item and
repeat the same one in the "Confirm Password" item. If the passwords
are not identical, you will see a warning message. If you entered the
same new password in both fields, you will see the message, "Saving
Data, Please Wait...". From now on, you need to use the new password
to open locked menus or locked channels.
Note: The default password is 0000.
5. Press [Exit] to leave the "Parental Lock" menu.
5.6 Power setting
When you select this option, you will see a screen as shown beside:
1. Automatic Standby: press [OK] to open the "Automatic Standby" menu.
• Automatic Standby: Press [VOLt/u] to select "Off" and "On".
• Time: Press [VOLt/u]to select "1hr" ~ "8hr".
2. LNB Power: If your receiver is connected to the LNB directly, you need
to set the LNB Power to "On". If your receiver is connected to a multi
switch (SMATV signal distribution system), it may be that you don't need
to provide the power to the LNB. But since this is depending on the kind
of installed distribution system, we recommend you to contact your
installer or to refer to the user manual of this system to get the
correct information. You can also change this setting and check if you
still can receive the channels. If the LNB Power is off and you still can
see all channels, we recommend this setting.
3. Press [Exit] button to leave this menu.
6. Tools
When you enter to "Tools" menu, you will see a screen like shown beside:
In "Tools" menu:
1. Press [CHp/q] to select the wanted item among Information, Quick
Setup, Game, Factory Default, Software Upgrade and SatcoDX Auto
Programming.
2. Press [OK] to enter the selected item.
6.1 Information
26
www.picomacom.com
PICO MACOM
5.6
6
CONTACT US TOLL FREE
800-421-6511
Advertisement
Table of Contents
