Multi Search; Tp Scan - Pico Macom SIRD-FTA-2 Owner's Manual

SIRD-FTA-2
7.. Scan Mode: You can select "Auto Scan", "Preset Scan" or "NIT Search"
to blind scan preset transponders or network transponders of the
selected satellite.
8. Search: Press [OK] to start scanning. In the lower part of the window, the
progress of scanning and the found channels are displayed.

4.2 Multi Search

When you enter the "Multi Search" menu, a window like shown beside will
open.
1. In the "Satellite" item press [VOLt/u] to select the satellite which you
want to scan or press [OK] to open the "satellite list" to select directly
with [CHp/q], and press [OK] to mark/unmark and [MENU] to finish
the selection. You can select several satellites in this menu. The system
will use DiSEqC1.0/1.1, DiSEqC1.2 and USALS functions to search the
marked satellites and scan channels.
2. On "FTA Only" item, press [VOLt/u] to select scanning of all channels or
just scanning of free channels. If you select "Yes", it will scan free
channels only.
3. On "Scan Channel" item, press [VOLt/u] to select the scanning range
from TV + radio channels, only TV channels or only radio channels.
4. On "Scan Mode" item, you can select "Auto Scan", "Preset Scan" or
"NIT Search" to blind scan preset transponders or network transponders
of the selected satellite.
5. Select "Search" and press [OK] to start scanning. In the lower part of the
window the progress of scanning and the found channels are displayed.
Press [Menu/Exit] to cancel or finish the scanning and saving the found
channels.

4.3 TP Scan

When you enter "TP Scan" menu, a window like the one shown beside will be
displayed.
1. In the "Satellite" item, press [VOLt/u] to select the satellite which you
want to scan or press [OK] to open the "satellite list" to select directly
with [CHp/q], press [OK] to confirm.
2. TP Index: Use [VOLt/u] to select the desired transponder or press [OK]
to open the TP list to select directly with [CHp/q], press [OK] again to
display the TP number where the channel can be found. Press [Red /
Green / Yellow] key on the RCU for the related functions.
• When you press [Red] it will display "New TP" in "TP Index" item. You
have to set the parameters of "TP Frequency", "Symbol Rate" for this
new transponder. Therefore use the number buttons of the RCU.
The available ranges are "3000~13450MHz" and "1000~45000KS/s".
• When you press [Green], a safety question will be displayed for
confirmation to delete the current transponder or not. If you select
"OK", the current transponder will be deleted and the total number of
transponders will be reduced.
18
www.picomacom.com
PICO MACOM
4.2
4.3
CONTACT US TOLL FREE 800-421-6511