Installation; Setup - Wells WATER-MAX Owner's Manual

UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from
the appliance before connecting electrical power or otherwise
performing any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any

installation.

Read all instructions in this manual carefully before starting
installation of this dispenser. READ AND UNDERSTAND ALL
LABELS AND DIAGRAMS ATTACHED TO THE DISPENSER.
Carefully account for all components and accessories before
discarding packing materials.
1 ea. WATER-MAX™ DISPENSER
1 ea. AIR OUTLET GUARD
4 ea. ADJUSTABLE LEGS
1 ea. WATER TANK ASSEMBLY with LID
1 ea. DELIMING SOLUTION BOTTLE
1 ea. LITERATURE PACKAGE
Store these components in a convenient place for later use:

SETUP

Verify that this dispenser installation is in compliance with the
specifications listed in this manual and with local code requirements.
THIS IS THE RESPONSIBILITY OF THE INSTALLER.
Recommended height of the faucet is 38" to 42" above the floor.
However, the actual installed height will vary with the requirements of the
individual store.
Install temperature gauge in water tank. Install plastic holding nut hand
tight only. Refer to exploded view, page 23.
For countertop installation
The counter at the installation location must be level, provide a
clear space at least 17-1/2"" deep and must be structurally capable
of safely supporting 150 pounds.
Set Water-Max™ on its back. Install the AIR OUTLET GUARD.
Guard is positioned on the bottom of Water-Max™, fully to the rear,
with the open portion toward the front. Install the REAR LEGS to
hold the guard in place.
Install the FRONT LEGS. Make certain all four legs have the
RUBBER FEET installed. Set Water-Max™ upright on the counter.
With the dispenser in its final installed location, adjust for level with
the adjustable legs. With a spirit level, check and adjust the
dispenser for level front-to-rear and side-to-side.
For wall mount installation:
Kits are available to wall mount Water-Max™. See important note at
right. Wall mount kits are listed on page 41.
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical and
plumbing codes. Failure can
result in personal injury and
property damage.
IMPORTANT:
Water dispensed from faucet
or nozzle of Water-Max™ will
be VERY HOT. Also, a one
gallon pitcher full of water will
weigh about 8-1/2 pounds.
IMPORTANT:
For wall mount installations
contact your Authorized Wells
Service Agency:
Only factory- produced wall
mounting brackets are
authorized for use with Water-
Max™.
Use of any mounting means or
method other than the
factory-produced bracket voids
all warranty on this appliance.
Additionally, owner and/or
installer assume all liability in
connection with injury or
damage resulting from use of
any mounting means or
method other than the
appropriate factory-produced
bracket.
5
INSTALLATION
WARNING:
Risk of
personal injury