Features & Operating Controls - Wells WATER-MAX Owner's Manual

FEATURES & OPERATING CONTROLS
Fig. 1 Features & Operating Controls - Water Max™ Dispenser
1. STRAIN RELIEF
12. DELIMING FITTING
22. POWER SWITCH
17. POWER INDICATOR
23. DISPENSER NOZZLE
25. ADJUSTABLE LEG
26. RUBBER FOOT
40. CONTROLLER
CIRCUIT BOARD
41. TERMINAL BLOCK
55. AIR FLOW CHANNEL
57. DELIMING FITTING
60. FUSES
62. TANK INDICATORS
63. STATUS INDICATOR
65. TANK POSITION
SWITCH
76. CONNECTOR
78. VIEW PORT
90. NAMEPLATE
(Left Side, Bottom) Field supply wiring enters the appliance here.
Tank mounted quick disconnect fitting for deliming procedure.
Energizes the appliance.
Glows when Water-Max™ is ON and operating normally.
Hot water is dispensed here. Inserting water tank lowers nozzle into "dispense" position.
Provides required clearance to counter, and allows unit to be leveled.
Allows Water-Max™ to operate without "walking" or sliding.
(Inside left side) Access by qualified technician only.
(Inside, under tank shelf) Field supply wiring connects here.
Access by qualified technician only.
Provides a measure of protection for transformer cooling air outlet.
Quick disconnect fitting attaches to deliming solution bottle.
Provide protection for electrical circuits.
LEFT - Tank must be delimed
RIGHT - Glows when tank is properly installed.
Glows when filling, flashes when controller is in "error" mode.
Held ON when WATER TANK depresses DISPENSER NOZZLE.
unless WATER TANK is in place.
Allows WATER TANK to connect to Water-Max™.
Also provides power to keep tank contents hot.
Allows digital readout of controller to be observed.
(Left side) Gives manufacturer information; lists model no., serial no. and electrical
specifications.
2
Unit will not operate