Table of Contents
Advertisement
GENERAL
USE AND CARE
SERVICE & REPAIR
Electrical:
208 Volts, Single Phase 35 Amps
240 Volts, Single Phase 35 Amps
NOTE: Requires a dedicated 50 Amp circuit
Plumbing:
Water Inlet: 1/4" Male Flare Fitting
Supply: 1/4" Female Flare supplied by a 1/4" O.D. or larger water supply line
NOTE: If water supply run from main supply line to Water-Max™ exceeds 12 feet,
a 3/8" O.D. or larger water supply line is required. Water supply line must be rated for
at least 180ºF.
For higher capacity, hook-up to a hot water line.
DO NOT use a saddle valve to connect to supply line.
IMPORTANT: This dispenser must be installed in compliance with all applicable
federal, state and local codes and ordinances.
Dimensions:
Height:
Width:
Depth:
Weight:
This manual covers Wells Water-Max™ hot water dispensers built after Nov. 1, 2002.
TABLE OF CONTENTS
SPECIFICATIONS
28-11/16"
10-1/16" (without tank)
22-7/16" (without tank)
74 lbs. (without tank)
APPLICABILITY
1
xi
1
2
4
4
5
6
Thank you for purchasing this
7
Wells Manufacturing Co.
9
Water-Max™ hot water
dispenser.
11
Proper installation, professional
12
operation and consistent
14
maintenance of this appliance
17
will ensure that it gives you the
very best performance and a
long, economical service life.
18
19
This manual contains the
20
information needed to properly
21
install the dispenser, to use
22
and care for the dispenser, and
24
to service and repair the
25
dispenser in a manner which
26
will ensure its optimum
41
performance.
41
15" (with tank installed)
25-1/4" (with tank installed)
150 lbs. (with tank installed and filled)
Hide quick links:
Advertisement
Table of Contents
