Wells WATER-MAX Owner's Manual page 17

TM
Deliming Water-Max
6. Fill bottle with tap water and wait 10 minutes.
•
Rinse solution bottle with warm tap water.
•
Fill solution bottle 2/3 full with warm tap
water and reattached quick-disconnect
cap.
•
Wait 10 minutes. Insert solution bottle in
quick-disconnect fitting. Push down on
bottle until latch "clicks".
•
Squeeze bottle, rinsing quick-disconnect
fittings and forcing deliming solution into
the tank.
•
Press the small plunger on the
TM
Water-Max quick-disconnect to release
the latch. While pressing button, lift
solution bottle straight up. Press the valve
on the solution bottle fitting to allow bottle
to return to shape.
7. Wipe fittings.
•
Wipe both quick-disconnect fittings with
•
a soft cloth.
The quick disconnect fitting are now
ready for the next deliming session.
8. Soak tank for 1 Hour and drain.
•
Press power switch to ON. Water-Max
will dispense water and any remaining
deliming solution into tank.
•
When Water-Max
press power switch to OFF. Allow
TM
Water-Max to set for 1 HOUR with
deliming solution in tank.
•
After 1 hour, drain pitchers of water from
tank until tank is empty.
•
Pour all water and solution from tank into
a sink.
Continued
TM
TM
stops dispensing,
DELIMING INSTRUCTIONS (continued)
15
CAUTION:
BURN HAZARD
TM
Water in Water-Max is
EXTREMELY HOT!