Cleaning Instructions - Wells WATER-MAX Owner's Manual

CLEANING INSTRUCTIONS

CAUTION:
BURN HAZARD
Water in tank is extremely
hot. Use care when draining
tank.
CAUTION:
HOT SURFACES
Exposed surfaces can be hot
to the touch and may cause
burns.
CAUTION:
SHOCK HAZARD
DO NOT submerge
tank in water
IMPORTANT:
DO NOT use bleach,
abrasive cleansers or
cleansers containing
chlorides.
CLEANING - DAILY
1. Wipe down unit
•
Spray a clean, sanitizer-soaked towel with TITAN Solution.
•
Wipe exterior surfaces.
CLEANING - MONTHLY
Clean Tank
1. Drain Tank
•
Press power switch to the OFF position.
•
Drain all water from tank into pitcher. As
each pitcher is full, turn faucet off and dump
pitcher of water into sink. It will take about
6 pitcher to completely empty tank.
2. Remove and clean tank.
•
Remove tank from hot water dispenser.
Take tank to sink to clean.
3. Clean probe, lid, nozzle, and faucet.
•
Wipe water level probe and top opening of
tank with a clean, damp, sanitizer-soaked
towel.
•
Wash, rinse, and sanitize tank lid in the 3-
compartment sink. Allow to air dry.
Check operation of faucet.
•
Fill the tank with cool tap water. Check the
operation of the dispensing faucet.
•
If the faucet leaks, see Problem Solving.
•
Drain Tank. Wipe down exterior of the tank
with a clean, damp, sanitized towel.
TM
Clean Water-Max
•
Use a soft bristle brush to remove any
calcium or lime build-up on the end of the
water input nozzle. Wipe water input nozzle
with a clean, damp, sanitized-soaked towel.
•
Wipe down entire unit with a clean,
damp, sanitizer-soaked towel.
Reinstall tank.
•
Reinstall tank on Water-Max
Press power switch to the ON position.
12
.
TM
shelf.