Schlage BE365 Programming/Operating Manual page 9

Enable/disable Turn Lock feature (BE365 ONLY) (preset is enabled)
NOTE: When Turn Lock feature is disabled, you must enter a valid user code to extend the
bolt.
6DPC
Create a temporary code (house sitter, plumber, etc.)
1. Add New User Code:
6DPC
2. Give person his/her code, but keep a written copy for yourself.
3. When code is no longer needed, delete User Code:
6DPC
Delete a user code if user code is unknown
IMPORTANT: This will delete ALL the user codes but not the programming code.
1. Delete ALL User Codes:
6DPC
2. Add New User Code:
6DPC
3. Repeat step 2 until all User Codes are reentered.
Ensure only you have codes to the lock
1. Change Programming Code:
6DPC
2. Delete ALL User Codes:
6DPC
3. Add New User Code:
6DPC
Restore ALL preset lock settings
IMPORTANT: Lock will be reset to the preset programming and user codes. All existing
user codes and current programming code will be erased.
1. Disconnect the battery.
(For FE575, see page 3. For FE595, see page 5. For BE365, see page 7.)
2. Press and release
3. Reconnect the battery and wait until
4. Within 10 seconds, press and hold
4DUC
New Reenter New
4DUC
Existing Reenter
6DPC
Reenter
4DUC
New Reenter New
6DPC
New Reenter New
6DPC
Reenter
4DUC
New Reenter New
.
is no longer lit.
until
4DUC
4DUC
4DUC
6DPC
4DUC
lights green and the lock beeps.
9