1
Measure Door Width
If the door is thinner than 1 " or thicker than 1 ", then the lock will not
fit properly on the door.
1 " to 1 "
2
Measure for Backset
If existing backset is not 2 " or 2 ", then the lock will not fit properly
on the door.
2 " or 2 "
3
Measure Hole Sizes
If hole sizes are larger than those shown, then the lock will not fit
properly on the door.
If hole sizes are smaller than those shown, see steps 4 and 5.
2 "
"
FE575/FE595 Door Preparation Instructions
For Door With Existing Holes
Drill Bits Needed:
",
", 1"
OR
1"
Tools Needed
" Hole Saw
4
If Needed, Enlarge Hole in Door
If hole in door is smaller than 2 ", then use 2 " hole saw to enlarge
hole.
5
If Needed, Enlarge Hole in Door Edge
If hole in door edge is smaller than
enlarge hole.
"
6
Check Strike (Door Jamb) Preparation
a.
Place new strike against door jamb.
b.
If strike does not fit properly, use pencil to trace around strike and
mark hole positions.
c.
If needed, use chisel and drill to correct door jamb preparation.
a
2 "
c
Pencil
2 "
2 " Hole Saw
", then use
OR
1"
b
©2005 Ingersoll-Rand Company
Printed in U.S.A
Rev. 11/05
Chisel
" or 1" drill bit to
Need help?
Do you have a question about the FE575 and is the answer not in the manual?
Questions and answers