Connecting Two Patterns [F2 (Append)]; Erasing A Pattern [F3 (Erase)] - Roland TD-12 Owner's Manual

Chapter 7. Sequencer (Recording/Editing)
Connecting Two Patterns
[F2 (APPEND)]
This connects two patterns to create one pattern. The pattern
specified as "Dst" will be first, and the pattern specified as
"Src" will be connected to it. The new pattern will be created
in "Dst."
fig.07-Apd1
Dst
1 2 3 4
1 2 3
Dst
1. Press [PATTERN] - [F4 (EDIT)].
The "PATTERN EDIT" screen appears.
2. Press [F2 (APPEND)].
"APPEND PATTERN" screen appears.
fig.07-Apd2_70
3. Press [CURSOR (up)] to move the cursor to
"Src."
4. Use [+/-] or [VALUE] to select the pattern that
will come later.
5. Press [CURSOR (down)] to move the cursor to
"Dst."
6. Use [+/-] or [VALUE] to select the pattern that
will come first.
7. Press [F5 (APPEND)].
The confirmation screen appears.
fig.07-Apd3_70
8. Press [F5 (EXECUTE)].
* To cancel, press [F1 (CANCEL)].
68
Src
1 2 3 4
+
4 5 6 7 8

Erasing a pattern [F3 (ERASE)]

This erases the pattern. Performance data is erased, while beat,
measure length, and other settings are left intact.
fig.07-Ers1
1 2 3 4
1 2 3 4
You can erase portions of the pattern, in measure units. The
erased portions become blank measures.
fig.07-Ers2
1 2 3 4
1 2 3 4
Although the data is erased, the pattern length is
unchanged.
1. Press [PATTERN] - [F4 (EDIT)].
The "PATTERN EDIT" screen appears.
2. Press [F3 (ERASE)].
The "ERASE PATTERN" screen appears.
fig.07-Ers3_70
3. When you want to erase selected measures or
part, press [F4 (MEASURE)].
The "ERASE PATTERN MEASURE" screen appears.
fig.07-Ers4_70
4. Press [CURSOR (left/right)] to select the
parameter.
5. Use [+/-] or [VALUE] to select the pattern, part,
and measures.
5 6 7 8
5 6 7 8
5 6 7 8
5 6 7 8