2 BIOS information
Change User Password
Select this item to set or change the user password. The User Password item on top of the screen
shows the default Not Installed. After you have set a password, this item shows Installed.
To set a User Password:
1. Select the Change User Password item and press ! .
2. On the password box that appears, type a password composed of letters and/or numbers, then
press ! . Your password should have at least six characters.
3. Confirm the password when prompted.
The message Password Installed appears after you have successfully set your password. The User
Password item now shows Installed. To change the user password, follow the same steps as in
setting a user password.
Password Check [Setup]
Allows you to select the access restriction to setup or even boot the system.
Configuration options: [Setup] [Always]
Boot Sector Virus Protection [Disabled]
Enables or disables Boot Sector Virus Protection.
Configuration options: [Disabled] [Enabled]
Chassis Intrusion [Disabled]
Enables or disables checking of Chassis Intrusion.
Configuration options: [Disabled] [Enabled]
Flash Write Protection [Disabled]
Enables or disables Flash Write Protection.
Configuration options: [Enabled] [Disabled]
50
1
A26361-D1711-Z120-1-7619, Edition