Sundance Spas Maxxus Installation & Owner's Manual page 18

C. Turn On Power
Turn on power to hot tub at the home's circuit breaker. The heater and
circulation pump will automatically activate. If the control panel LCD
flashes water temperature and "COOL" or "ICE", the pump 1 will also acti-
vate in low speed. If this occurs, refer to page 39-40 for additional infor-
mation.
D. Activate Jets
Depress the JETS 1 sensor pad on the control panel once to
activate pump #1 in low speed; then press a second time for
high speed.
E. Add Start-Up Chemicals
Add the hot tub water chemicals as recommended by your Sundance
Dealer. See section titled "WATER QUALITY MAINTENANCE" (page
37) for general guidance.
F. Set Hot Tub To Heat
To warm hot tub water to a comfortable temperature, follow these steps:
• The LCD display on the control panel displays the actual tempera-
ture of the hot tub water. Press either the COOLER (Down) or
WARMER (Up) sensor pad once to display the "set" temperature
for 5 seconds. If you want the water to heat to a different tem-
perature, simply press COOLER or WARMER within 5 seconds.
The set temperature advances or decreases by one degree each time
one of these sensor pads is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Important Heater Details:
• The maximum temperature for which the hot tub can be set is 104°F (40°C)
and the minimum is 80°F (2 7°C).
• If hot tub is hooked up to 40 amp service - turn off all high speed pumps to
operate heater. Note: pumps #2 and pump #3 run only in high speed.
• Setting the thermostat at maximum will not accelerate the heating process.
This will only result in a higher ultimate temperature.
• The heater operates until the water reaches the programmed "set tempera-
ture", then turns off. The heater will reactivate after the water cools to
approximately 1.5° below the "set temperature."
G. Place Cover On Hot Tub
• Keeping the insulating cover in place anytime the hot tub is not in use will
reduce the time required for heating, thereby minimizing operating costs.
Page 14