Assembling The Rear Constant Velocity Joint - Yamaha YFM660FS Grizzly 4x4 Supplementary Service Manual

REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR
AND DRIVE SHAFT
ASSEMBLING THE REAR CONSTANT
VELOCITY JOINT
1.Apply:
Lithium-soap base grease
G
(into the ball joint assembly)
2.Install:
Dust boots 1
G
Boot bands 2, 3
G
*****************************************************
Installation steps:
G
Apply lithium-soap base grease into the dust
boots.
Lithium-soap base grease:
50 g (1.8 oz) per dust boot (rear
wheel side)
60 g (2.3 oz) per dust boot (final
gear case side)
G
Install the dust boots.
G
Install the dust boot bands.
NOTE:
The new boot bands may differ from the orig-
G
inal ones.
The dust boots should be fastened with the
G
boot bands 3 at the grooves in the joint
shaft.
*****************************************************
3.Check:
Free play (thrust movement)
G
Excessive play → Replace the joint assem-
bly.
7 - 22
DRIV
New