Changing The Coolant - Yamaha YFM660FS Grizzly 4x4 Supplementary Service Manual

CHECKING THE COOLANT LEVEL/

CHANGING THE COOLANT

3 - 32
3.Check:
Coolant level
G
The coolant level should be between the
minimum level mark a and maximum level
mark b.
Below the minimum level mark → Add the
recommended coolant to the proper level.
CAUTION:
Adding water instead of coolant lowers
G
the antifreeze content of the coolant. If
water is used instead of coolant, check
and if necessary, correct the antifreeze
concentration of the coolant.
Use only distilled water. However, soft
G
water may be used if distilled water is not
available.
4.Start the engine, warm it up for several min-
utes, and then turn it off.
5.Check:
Coolant level
G
NOTE:
Before checking the coolant level, wait a few
minutes until the coolant has settled.
6.Install:
Fuel tank side panel (left)
G
Seat
G
Refer to "SEAT, CARRIERS, FENDERS
AND FUEL TANK".
CHANGING THE COOLANT
1.Remove:
Seat
G
Fuel tank side panel (left)
G
Engine side cover
G
Front carrier
G
Front fender panel
G
Coolant reservoir cover
G
Refer to "SEAT, CARPIERS, FENDERS
AND FUEL TANK".
Left footrest board
G
Refer to "FOOTREST BOARDS".
CHK
ADJ