Replacing The Front Brake Pad - Yamaha YFM660FS Grizzly 4x4 Supplementary Service Manual

FRONT AND REAR BRAKES
CAUTION:
Disc brake components rarely require dis-
assembly. DO NOT:
disassemble components unless abso-
G
lutely necessary;
use solvents on internal brake compo-
G
nents;
use spent brake fluid for cleaning; (use
G
only clean brake fluid)
allow brake fluid to come in contact with
G
the eyes, as this may cause eye injury;
splash brake fluid onto painted surfaces or
G
plastic parts, as this may cause damage;
disconnect any hydraulic connection, as
G
this would require the entire brake sys-
tem
cleaned, properly filled and bled after
reassembly.

REPLACING THE FRONT BRAKE PAD

NOTE:
It is not necessary to disassemble the brake
caliper and brake hose to replace the brake
pads.
1.Measure:
Brake pad wear limit a
G
Out of specification → Replace the brake
pad as a set.
2.Install:
Brake pads
G
Brake pad spring
G
NOTE:
Always install new brake pads, brake pad shim
and brake pad spring as a set.
8 - 12
CHAS
to be disassembled,
Brake pad wear limit:
1 mm (0.04 in)
drained,