Table of Contents
Advertisement
Dust Port
DO NOT attach the dust port if you do not
intend to connect your planer to a dust col-
lection system. Accumulated wood chips
could cause a malfunction, resulting in per-
sonal injury or damage to the planer.
Components and Hardware Needed:
Dust Port ........................................................... 1
Hex Bolts M6-1 x 12 .......................................... 3
Cap Screws M6-1 x 12 ...................................... 3
Flat Washers 6mm ............................................ 3
Lock Washers 6mm ........................................... 3
Hex Nuts M6-1 .................................................. 3
To install the dust hood:
1.
Secure the dust port to the planer upper
cover with the hex bolts, hex nuts, and flat
washers, as shown in Figure 8. It will be nec-
essary to reach inside the port opening with
a wrench to hold the nut while tightening the
hex bolts.
Figure 8. Dust port attached.
2.
Use the cap screws and lock washers to
secure the dust port to the planer head cast-
ing.
G1021X 15" Extreme Series Planer
Gearbox Oil Level
Before starting your machine for the first time,
make sure the gearbox has oil.
To check the gearbox oil level:
1.
Using a 14mm wrench, remove the gearbox
fill plug (Figure 9).
Qty
Figure 9. Gearbox fill plug location.
2.
Using the short end of the 6mm hex wrench,
dip it inside the fill hole and remove it.
—If the end of the hex wrench is coated
with oil, then the gearbox oil level is okay.
Replace the fill plug and skip to the next
section.
—If the end of the hex wrench is not coated
with oil, then you need to add more oil.
Refer to Page 23 for instructions on how
to do this.
-15-
Advertisement
Table of Contents
