Digital Output; Analog Inputs - Lyngdorf Audio Millennium MkIV Owner's Manual

Digital Output

The selected analog or digital input source is relayed to the digital output. Use the output
for recording CD's etc.

Analog Inputs

One of the two 5-pole XLRs is dedicated for the optional Millennium ADC, which will be
clock synchronised and powered by the Millennium. When the Millennium ADC is
connected, one of four analog inputs can be selected by toggling through input Al to 44.
When the Millennium ADC is not present, the AI indicator will flash and the Millennium
returns to the previous digital input.
Address setting for network operation
When used in a network in connection with either a RCS/TCS or another Millennium it is
essential to set both the communication speed and address correctly. The address usage
in a network is restricted by the following rules:
Address
0
1
2-..
If more than one amplifier is present in the network different addresses must be appointed
to each amplifier by the Millennium software.
The INPUT/AUX connectors on the back panel are used for connectivity over standard
RJ12 cables in a suitable length. For Slave amplifiers the input is used to pass information
from the Master or a RCS/TCS to the amplifier. For Master amplifiers the broadcast
information will be passed to the slave on the AUX connector which also passes any input
information in a daisy chain to the next Lyngdorf product.
Functionality
Reserved
Master
Slave
- 13 -
Comment
Normally not used
Master, TCS, RCS
Slave