Select Or Adjust The Media Sensor; Select The See-Through Sensor; Adjust The Reflective Sensor - Argox F1 User Manual

Select or Adjust the Media Sensor

This printer uses two types of media sensors: See-through and reflective.
The default is see-through sensor No 1.

Select the See-through Sensor

The standard see-through sensor is in a fixed position and enabled from the
control panel. (Figure 23)

Adjust the Reflective Sensor

1. Press down the Thermal Print Head (TPH) release lever to release the print
head module.
2. Lift the print head module to expose the media sensor cover. (Figure 24)
3. Slide the media sensor until the reflective sensor aligns with the gap or
notch (Figure 25)
.
Figure 24
Figure 23
47
Figure 25