Password Parameters - Argox F1 User Manual

Password Parameters

The F-Series printer has three password levels. When you enter the setup
mode on the control panel, parameters which are not protected by password
are displayed. You must enter a correct password to enter AUTHORISED
SETUP 1 and AUTHORISED SETUP 2. The password levels and default
passwords are shown in the following table.
Password Level
3
2
1
To enter a password when prompted, complete the following steps:
1. When the printer displays AUTHORISED SETUP X, press <ENTER>.
The LCD displays password and the number 0000.
2. Enter the four-digit password for the password level displayed or for a
higher level.

The left <←> and right <→> buttons select the digit position.
 The up <↑> and down <↓> buttons change the selected digit's value.
3. After entering the password, press <ENTER>.
Level name
AUTHORISED SETUP 2
AUTHORISED SETUP 1
BASIC SETUP
50
Default Password
9999
1234
No password