Authorised 2 - Argox F1 User Manual

0 (0~4ips)
LOAD DEFAULT

Authorised 2

RTC SETUP
DATE (MM-DD-YY)
TIME (HH:MM:SS)
ADVANCED CUT
WITH BACKFEED
W/O BACKFEED
ADVANCED PEEL
WITH BACKFEED
W/O BACKFEED
The default of base speed is 0.
Reset Printer and panel settings.
Press <ENTER> and a warning message
―ARE YOU SURE? YES/CONFIRM‖
appears. Select with the up <↑> and down
<↓> buttons. Press <ENTER> to confirm.
This function appears on the LCD display
only when the RTC module is installed. Press
<ENTER> and press the right <→> button to
move to the next digit. Use the up <↑> and
down <↓> buttons to select a value. Press
<ENTER> to accept the value. (Note: This
parameter only appears if the RTC card is
installed.)
Change current date if RTC module is
installed. Format: MM-DD-YY
Change current time if RTC module is
installed. Format: HH:MM:SS
Enable or disable backfeed after label cut.
This function does not appear if cutter
function is disabled. (Note: This parameter
appears only if cutter is installed.)
Enable backfeed after cut.
Disable backfeed after cut.
Enable or disable backfeed after a label is
peeled and removed. (Note: This parameter
only appears if peeler is installed.)
Enable backfeed after peel.
Disable backfeed after peel.
57