Argox F1 User Manual page 56

ROTATE CUTTER
OFFSET
TEAR OFFSET
0mm (-3~+3)
PEEL OFFSET
0mm (-16~+16)
CUT OFFSET
0mm (-16~+16)
VERTICAL
0mm (-30~+30)
HORIZONTAL
0mm (-99~+99)
TPH OFFSET
0mm (-3~+3)
PRINT WIDTH
102mm (10~104mm) The print width default value is 10mm.
DARKNESS
8 (1~15)
SPEED
3IPS (1~6 IPS)
PRINT OUT
This parameter allows you to rotate cutter.
Press <ENTER> to activate. Note: The
parameter shows only if a cutter is installed.
This option fine tunes the media stop location
Sets label tear off offset.
Sets label peeling offset.
Sets label cutting offset.
Change the vertical position of the whole
label format.
Change the horizontal position of the whole
label format.
Change the thermal print head (TPH) vertical
offset.
Sets maximum print width. Objects that
exceed the maximum print width do not print.
Adjusts print darkness for consistent high
quality printing. Press up <↑> to increase
value or down<↓> to decrease value.
The default for print darkness is 8.
Controls the rate of label movement during
the printing process. Press up <↑> or down
<↓> to choose the value.
The default for print speed is 3 ips.
Prints out current printer configuration
settings, or prints out downloaded form list,
downloaded font list, downloaded graphic
list. Press the up <↑> and down <↓> buttons
53