Maintenance - Argox F1 User Manual

Maintenance

Argox recommends using following material to clean the printer:

100% ethanol

Cotton swab

Blower brush
CAUTION!
1. The print head gets hot and could cause severe burns. Always allow the
print head to cool before maintenance.
2. Argox is not responsible for damage caused by the use of cleaning fluids
on this printer.
Component
Print head
Platen roller
Tear-off/Peel-off bar
Sensor
Procedure
1. Open the print head and
remove the media and
ribbon.
2. Using the swab and 100%
ethanol, wipe the print
head from end to end.
Manually rotating the platen
roller, clean it thoroughly with
100% ethanol and swab.
Use the swab to remove
excess adhesive from the
tear-off/peel-off bar.
Air blow or vacuum.
60
Frequency
Clean the print head
after each change of
ribbon.
Clean the platen roller
when changing a new
label roll.
Once a month.
Once every six
months.