M-Nav 750 | User Manual
3 Install the M-Nav 750 in a Vehicle
Note: These installation instructions assume that the Qube tracking device is already installed in
the vehicle and that the RJ-45 cable has been fed through the dashboard, ready for connection to
the M-Nav 750.
When you have assembled the docking cradle, you can either:
• use the suction mount to attach the M-Nav 750 to the vehicle windscreen, or
• use the optional hard installation kit to attach the M-Nav 750 to a hard surface, such as the
top of the dashboard
3.1
Assemble the Docking Cradle
Connect the suction mount to the cradle fi xture, as shown, to form the docking cradle.
1. Connect the suction
mount to the docking
cradle here.
3.2
Windscreen Installation
Note: Some windscreens contain areas of tinted glass that may interfere with the GPS signal. Do
not mount the M-Nav 750 in these areas.
Read the Important Safety Information in Section 1.1.
Decide where to locate the suction mount on the windscreen. Use the alcohol swab to thoroughly
clean that area of the windscreen, then dry the area with a soft, lint-free cloth.
Press the suction cup (part of the docking cradle) fi rmly against the windscreen for 3 seconds.
Push the lever down to vacuum-seal the suction cup to the windscreen.
Now you are ready to add the M-Nav 750 to the docking cradle. See Section 3.3.
2. Slide the suction
mount to the right so
that it clicks into place
under this clip.
10