Add The M-Nav 750 To The Docking Cradle - Navman M-Nav 750 User Manual

3.3

Add the M-Nav 750 to the docking cradle

IMPORTANT: Check the M-NAV 750 internal battery switch is ON before you add the M-Nav
750 to the docking cradle. You should not need to touch this switch again after it has been
switched ON.
Insert the RJ-45 cable (already fed through the dashboard from the Qube tracking device) into
the RJ-45 connection socket at the back of the docking cradle.
Put the bottom of the M-Nav 750 into the docking cradle, and then push the M-Nav 750 gently
back until it snaps into place with an audible click.
IMPORTANT: The M-Nav 750 must be in the docking cradle and connected to the Qube
tracking device in order for you to report your driver status, send and receive messages and
otherwise communicate with your fl eet administrator through the OnlineAVL2 application.
The start up screen will display automatically. See Section 4.
Adjust the angle of the M-Nav 750 using the pivot screw on the docking cradle to give a
comfortable viewing position.
Note: If you are leaving the vehicle for a while, we recommended that you remove the M-Nav
750 from the docking cradle and store it in a safe place.
11
M-Nav 750 | User Manual