Table of Contents
Advertisement
Video Input
Input Source Selection (Component, RGB Scart 21-pin)
Direct Operation
Choose Computer 1 by pressing the INPUT button
on the top control or press the COMPUTER button
on the remote control.
Before using these buttons, correct input source
should be selected through Menu operation as
described below.
Menu Operation
1
Pr e s s t h e M E N U b u tt o n t o d i s p l ay t h e
On-Screen Menu. Press the Point
to move the red framed pointer to the Input
Menu icon.
2
Press the Point
arrow pointer to Computer 1 and then press
the SELECT button.
3
After the Source Select Menu appeared for
Computer 1, move the pointer to Component or
RGB (Scart) and then press the SELECT button.
W h e n t h e i n p u t s o u r c e i s
Component
coming from video equipment
co nn ec te d to the CO MPUTER
IN 1/COMPONENT IN terminal
with a Component-VGA Cable(not
supplied), select Component.
W h e n t h e i n p u t s o u r c e i s
RGB (Scart)
coming from video equipment
connected to the COMPUTER IN
1/COMPONENT IN terminal with
a Scart-VGA Cable(not supplied),
select RGB (Scart).
✔
Note:
• When the Input Search function is set On1
or On2, the input signal will be searched
automatically (p.46)
• C o m p u t e r 2 i s n o t d i s p l aye d w h e n t h e
COMPUTER IN 2/MONITOR OUT terminal is
set as Monitor out. (p.47)
36
7 8
buttons to move the red
ed
Top Control
Remote Control
✳ See Note at the bottom of this page.
buttons
Input Menu
Computer
1
INPUT button
INPUT button
Computer 1
Computer 2
Video
COMPUTER button
COMPUTER button
Computer 1
Computer 2
Input Menu icon
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Source Select Menu
Move the pointer to
Component or RGB(Scart)
and press the SELECT
button.
✳
✳
Advertisement
Table of Contents
