Table of Contents
Advertisement
Appendix
Some displays are not seen
during operations
PIN code dialog box appears at
the start-up
Computer 2 cannot be selected
The Terminal function cannot be
selected
The Remote Control does not
work
The Top Control does not work
WARNING:
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you
purchased the projector or the service center. Give the model number and explain about the
problem. We will advise you how to obtain service.
The CE Mark is a Directive
c o n fo r m i t y m a r k o f t h e
European Community (EC).
Pixelworks ICs used.
58
– Check the Display item. (See page 43.)
– PIN code lock is being set. Input a PIN code (1234 or numbers
you have set). (See pages 18, 49 and 50.)
– Select Computer 2 at the Terminal function. (See page 47 .)
– The Terminal function cannot be selected after Computer
2 is selected. Select other input source such as Computer
1 or Video with the INPUT button on the top control, the
COMPUTER button or the VIDEO button on the remote
control so that the Terminal function can be selected.
– Check the batteries.
– Make sure there is no obstruction between the projector and
remote control.
– Make sure you are not too far from the projector when using
the remote control. Maximum operating range is 16.4' (5 m).
– Make sure the code of the remote control is conformed to
that of the projector. (See page 48.)
– Unlock the Key lock function for the remote control. (See page
49.)
– Unlock the Key lock function for the top control of the projector.
(See page 49)
This symbol on the nameplate means
the product is Listed by Under writers
Laboratories Inc. It is designed and
manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and
electrical hazards.
Advertisement
Table of Contents
