Table of Contents
Advertisement
Setting
On start
When this function is "On", the projector is
automatically turned on just by connecting the AC
power cord to a wall outlet.
✔
Note:
• Be sure to turn the projector off properly (see
"Turning Off the Projector" on page 19). If the
projector is turned off in the incorrect sequence,
the On start function does not operate properly.
Lamp control
This function allows you to change brightness of the
screen.
Normal . . . . . normal brightness
Auto . . . . . . . brightness according with the
Eco. . . . . . . . lower brightness reduces the
Remote control
This projector provides two different remote control
codes: the factory-set initial code (Code 1) and the
secondary code (Code 2). This switching function
prevents remote control interference when operating
several projectors or video equipment at the same
time.
When operating the projector in "Code 2", both the
projector and the remote control must be switched to
"Code 2".
To change the code for the projector:
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for 10 seconds or more. After changing the
code, make sure the remote control operates properly.
✔
Note:
If the batteries are removed from the remote
control for a long period of time, the remote
control code will be reset.
48
input signal
lamp power consumption and
extends the lamp life.
On start
Remote control
Press and hold
MENU and
IMAGE buttons
for more than
10 seconds.
Advertisement
Table of Contents
