Husqvarna Rider ProFlex 18 Operator's Manual page 46

LUBRICATION
6. Cutting unit
Remove the nose cowling.
Lubricate using an oil can:
A. Safety catch
- Joints and bearings
Lubricate with grease:
B. Inner stud
C. Slot for attachment frame
7. Triangular link
Grease nipple located behind the right side front
wheel.
Lubricate with a grease gun until grease is
squeezed out.
Use molybdenum sulphide grease.
8. Driver's seat
Tip up the seat.
Lubricate the linkage of the scissor springs using an
oil can; there are 8 lubrication points.
Lubricate the seat leg length adjustment
mechanism using an oil can.
Lubricate the leg length adjustment rails using an
oil can.
9. Throttle and choke wires, lever
bearings
Remove the right side cover from the lever housing
(3 screws) and open the engine hood. Lubricate the
exposed ends of the wires using an oil can,
including the ends at the engine. Move the levers
through their full range of travel and lubricate again.
Lubricate joints, locks and bearings for the cutting
deck control levers using an oil can.
NOTE
Take care when fitting: The fine-threaded screw for
the side cover must be fitted from the outside.
Refit the side panel on the lever housing.
45
English –