Collection Bags - Grizzly G5954 Owner's Manual

3. Press-fit the 4-in-1 inlet adapter onto the col-
lector inlet, as shown in Figure 8.
Figure 8. Installing 4-in-1 inlet adapter.

Collection Bags

Components and Hardware Needed:
Upper Bag Supports .......................................... 2
Upper Bag Support Extenders .......................... 2
Lower Support ................................................... 1
Lower Support Foot Pad ................................... 1
Upper Collection Bags ...................................... 2
Lower Collection Bags ....................................... 2
Flange Bolts ⁄ -18 x ⁄
5 3
16 4
Flange Bolts ⁄ -20 x ⁄ ...................................... 4
1 1
4 2
To set up the collecton bags:
1. Screw the lower support foot pad onto the
bottom of the lower support.
2.
Attach the lower support to the Collector
using two ⁄ -18 x
5 3
16
G5954 5HP Dust Collector
Qty
..................................... 6
⁄ hex bolts.
4
3.
Attach each upper bag support to an upper
bag support extender using the
bolts.
4. Attach each upper bag support to the Collector
using two ⁄ -18 x
5 3
16
5. Hang an upper bag from an upper bag sup-
port extender.
6.
Pull the bottom of the upper bag over the lip
of the collector below it, and fasten it in place
with a bag clamp, as shown in Figure 9.
Figure 9. Fitting bag onto collector.
7. Repeat Steps 4 & 5 for the other upper bag.
8. Fit a lower bag over the bottom lip of the
collector, and fasten it in place with a bag
clamp.
9. Repeat Step 6 for the other lower bag.
1 ⁄ -20 x 1 ⁄ hex
4 2
⁄ hex bolts.
4
-13-