EMS XtremeRGB-Ex1 User Manual page 8

Specification
•
Board Format
•
Connectors
•
Maximum Sample Rate:
•
Video Sampling:
•
Video Capture Memory:
•
Analog RGB Mode Support:
•
DVI Single Link Mode Support:
•
HD Modes
•
Input Mode Detection:
•
Pixel Transfer Formats:
•
Update Rate:
•
Video Format Options:
•
Operating System Support
•
Power Requirements
•
Operating Temperature:
•
Storage Temperature:
•
Relative Humidity
•
Analog Input Range:
•
Input Offset:
•
Hsync:
•
Vsync:
PCIe x4 low profile card, 68.9mm x 167.6mm
PCIe bus master with scatter gather DMA providing maximum data rate of
480MB/s
One DVI-I Type connector
170 Mpixels per second analog RGB or 165MHz DVI
Analog RGB: 24 bits per pixel / 8-8-8 format
32MB per channel (updated in real time). Triple buffered
640 x 480, 800 x 600, 1024 x 768, 1280 x 1024, 1600 x 1200, 1920 x 1080,
2048 x 1536, Custom modes
640 x 480, 800 x 600, 1024 x 768, 1280 x 1024, 1600 x 1200, 1920 x 1080,
1920 x 1200 and Custom modes
1080p, 1080i, 720p, 567p, 480p and 480i using a Component HD connector
(HDCP not supported)
Automatic detection of input modes in hardware enabling the tracking of mode
changes in the source signal
RGB: 5-5-5, 5-6-5 or 8-8-8 pixels
YUV 4:2:2 modes: UYVY, YUY2 or YVYU
MONO: 8bit
User defined, captured frame rate will match the source providing max data
rate (480MB/s) is not exceeded.
Triple buffered to eliminate tearing artifacts
Analog RGB plus HSync and VSync (5 wire)
Analog RGB with Composite Sync (4 wire)
Analog RGB with Sync on Green (3 wire)
DVI Single Link
Windows® XP, Windows® Vista, Windows® Server 2003, Windows® Server
2008 and Windows® 7 (x86 and x64 Operating Systems)
Max current at +3.3V – 0.25A
Max current at +12V – 0.5A
Max power – 6.8 Watts
0 to 35 deg C
-20 to 70 deg C.
5% to 90% non-condensing
Min 0.5Vpp Max 1.0Vpp
+/-2V
15kHz - 110kHz
No hardware limits, typically 25Hz - 200Hz for real signals