Table of Contents
Advertisement
Installing the XtremeRGB-Ex4+ Capture Card
You are likely to need a flat blade and a Phillips head screwdriver for the installation of the capture
card; it would be useful to have these to hand before you begin.
Installing the card is a simple process, follow the steps below to be up and running in a few minutes:
•
Power down the PC (including peripherals), switch off at the mains and disconnect all the
cables connected to the computer, noting the positions for accurate reconnection. Remove
the PC cover
•
Locate a vacant PCIe (x4 or above) slot on the motherboard and remove the backing plate.
(retain all screws)
identify a PCIe (PCI-express) slot. If the card is forced into a 32 or 64 bit PCI or PCI-X
slot it will be irreparably damaged when the system is powered up and the warranty
will be
void.
•
Remove the card from its packaging and secure it firmly into the empty PCIe slot. Extreme
care should be taken when securing the card into the slot as some motherboards may
have components that impede the siting of the card
•
Screw the card bracket to the back panel of the PC and replace the cover
•
Re-connect all cables to the PC
•
Connect the BNC16 Input cable
•
Power up the PC and commence the software installation
Connections
The XtremeRGB-Ex4+ has two connectors. The top connector is a DVI-I connector and the bottom
connector is a D-Type connector.
The DVI-I Connector
Connect to the source using:
•
DVI-D Cable
•
DVI-A Cable
•
Analog VGA (RGB) cable (adapter supplied)
•
HDMI cable (adapter supplied as optional)
•
Component HD cable (adapter supplied as optional)
Connect one end of the cable to the source. Connect the other end of the cable to DVI-I type
connector (top connector) located on the XtremeRGB-Ex4+ card in your computer.
DVI to VGA adapters are supplied for use with an analog VGA (RGB) Cable.
If in doubt consult your motherboard documentation to correctly
Advertisement
Table of Contents
