Table of Contents
Advertisement
Connections
The XtremeRGB-Ex2 card has two DVI-I type connectors for two separate, simultaneous inputs. The
top connector is referred to as Channel 1, the bottom connector, Channel 2.
Connect to the source using:
•
DVI-D Cable
•
DVI-A Cable
•
Analog VGA (RGB) cable (adapter supplied)
•
HDMI cable (adapter supplied as optional)
•
Component HD cable (adapter supplied as optional)
Connect one end of the cable to the source. Connect the other end of the cable to DVI-I type
connector located on the XtremeRGB-Ex2 card in your computer.
DVI to VGA adapters are supplied for use with an analog VGA (RGB) Cable.
Installing Multiple Cards
Up to 32 cards can be installed in a system providing a maximum of 64 capture channels using the
XtremeRGB-Ex2. Combinations of XtremeRGB capture cards in the same machine are supported by
the driver.
In order to control the order in which the driver uses the cards, it is recommended when installing
multiple cards that the J5 links on the XtremeRGB-Ex2 are configured. Each card should be
configured as follows:
DirectShow
If you change the link ordering after installation you must run dplinks.exe. This program will update
the existing input names used by the windows DirectShow interface.
Advertisement
Table of Contents
