EMS XtremeRGB-Ex1 User Manual page 25

Xtremergb range of video capture cards
Table of Contents

Advertisement

Specification
Board Format
Connectors
Maximum Sample Rate:
Video Sampling:
Video Capture Memory:
Analog RGB Mode Support:
DVI Single Link Mode Support:
HD Modes
Input Mode Detection:
Pixel Transfer Formats:
Update Rate:
Video Format Options:
Operating System Support
Power Requirements
Operating Temperature:
Storage Temperature:
Relative Humidity
Analog Input Range:
Input Offset:
Hsync:
64 bit, up to 66MHz PCI-X, half size plug-in card 105mm x 170mm.
PCI bus master with scatter gather DMA providing maximum data rate of
480MB/s
Two DVI-I Type connectors
170 Mpixels per second analog RGB or 165MHz DVI
Analog RGB: 24 bits per pixel / 8-8-8 format
64MB (updated in real time). Triple buffered
640 x 480, 800 x 600, 1024 x 768, 1280 x 1024, 1600 x 1200, 1920 x 1080,
2048 x 1536, Custom modes
640 x 480, 800 x 600, 1024 x 768, 1280 x 1024, 1600 x 1200, 1920 x 1080
Custom modes
1080p, 1080i, 720p, 567p, 480p and 480i using a Component HD connector
(HDCP not supported)
Automatic detection of input modes in hardware enabling the tracking of mode
changes in the source signal
RGB: 5-5-5, 5-6-5 or 8-8-8 pixels
YUV 4:2:2 modes: UYVY, YUY2 or YVYU
MONO: 8bit
User defined, typically up to 60 frames per second, limited by available PCI-X
or PCIe bandwidth
Triple buffered to eliminate tearing artifacts
Analog RGB plus HSync and VSync (5 wire)
Analog RGB with Composite Sync (4 wire)
Analog RGB with Sync on Green (3 wire)
DVI Single Link
Windows® XP, Windows® Vista, Windows® Server 2003, Windows® Server
2008 and Windows® 7 (x86 and x64 Operating Systems)
Max current at +3.3V – 0.5A
Max current at +5V – 1.7A
Max power - 10 Watts
0 to 35 deg C
-20 to 70 deg C.
5% to 90% non-condensing
Min 0.5Vpp
Max 1.0Vpp
+/-2V
15kHz - 110kHz

Advertisement

Table of Contents
loading

Related Products for EMS XtremeRGB-Ex1

This manual is also suitable for:

Xtremergb-ex2Xtremergb-iiXtremergb-ex4+Xtremergb-ex8

Table of Contents