Table of Contents
Advertisement
Firmware Upgrades
The XtremeRGB-Ex1 cards allow firmware upgrade to be completed on site rather than returning the
card to EMS. Whenever a firmware upgrade is performed, LK4 MUST BE FITTED on the
XtremeRGB-Ex1. To perform the upgrade, follow the step-by-step instructions provided by the
upgrade application.
In the unlikely event that something goes wrong during the upgrade process (e.g. System power
outage) it is possible to revert to the factory settings by powering down the system, temporarily
removing LK4 then powering up the system with the link removed. Once the system has rebooted,
replace the LK4 link (whilst the system is powered up) and restart the firmware upgrade process.
It should be noted that the latest driver installation program includes an automatic firmware update, if
required. Therefore, prior to installing the application and driver, ensure that LK1/ LK4 is fitted.
Extended Display Identification Data (EDID) - Disable Links
EDID is data provided by a display monitor and sent to the graphics device detailing the monitor's
capabilities thereby enabling a system to identify the type of monitor that is attached.
The graphics device installed on your machine will see the card as a monitor and will expect to
receive the EDID data from the card.
However, in rare circumstances it may be necessary that the XtremeRGB-Ex1 does not report an
EDID of any kind. In this instance EDID support can be disabled by removing link LK3 on the
XtremeRGB-Ex1
Software Installation
The XtremeRGB-DVI software (driver and application) is installed by inserting the CD that was
shipped with your card into your CD ROM drive. The installation process should start automatically.
Should the CD fail to autorun use Explorer to browse the CD, locate then double click on install.exe
file e.g. d:/install.exe and click on Install Software... and follow the installation wizard instructions as
prompted.
Regular software updates are available from our website: www.ems-imaging.com
Also available on the EMS CD:
•
The Release Notes - The release notes contain the latest information on the XtremeRGB-
Ex1 including:
•
Installation instructions.
•
Release history
•
Known problems
•
Troubleshooting
•
The application Help File - Instructions on how to use the application. The help file is in
CD:\XtremeRGB Manual\XtremeRGB_help.pdf
•
Test patterns to assist in setting up an analog RGB / DVI source (see help file topic How to
set up an RGB / DVI Source)
Application Overview
The application displays the source in a window; it has the following features:
•
Scales the data to fit in the window
Advertisement
Table of Contents
