GE Security Simon User Manual page 10

Note
Any sensors that are
bypassed by the system will
NOT be protecting your
home.
4
¾ Arming Your System with Doors & Windows Closed
1. Close all doors and windows.
2. Press Arm Doors & Windows button.
3. Enter Access Code (if needed).
Panel announces, Doors and windows on, Arm Doors & Windows light will be lit and
the exit delay will begin.
¾ Arming Your System with Doors or Windows Open (Indirect Bypassing)
1. Close all doors and windows except the ones you wish to remain open.
Press Arm Doors & Windows button.
2.
3. Enter Access Code (if needed).
Panel announces any protected doors or windows that are open. Any sensors that are
open when the system is armed will be bypassed after exit. Arm Doors & Windows
light will be lit and the exit delay will begin.
¾ Arming Your System with No Entry Delay
Note
No Entry Delay can be used in two ways. First, you can use this feature when you're staying at
home, after you've armed the system (i.e. when you're asleep). Second, you can use this when
you're away from your home. To avoid causing an alarm, you must disarm the system with a
remote handheld touchpad or keychain before entering your home. Check with your installer to
find out how this option is programmed.
1. Close all doors and windows.
2. Press Arm Doors & Windows button twice.
3. Enter Access Code (if needed).
Panel announces, Doors and windows on, no entry delay. Arm Doors & Windows light
will blink and the exit delay will begin.
¾ Arm Motion Sensors
1. Press Arm Motion Sensors button once.
2. Enter access code (if needed).
Panel announces, Motions on. Arm Motion Sensors light will be lit and the exit delay
will begin. This feature is most likely used when there is no one on the premises
¾ Disarming Your System
1. Upon reentering your home the entry delay will begin.
2. Status beeps will sound.
3. Enter your access code using the Code buttons.
Panel announces, System disarmed and the Disarm light will be lit.
! If you enter you home and you hear alarm sirens, or if controlled lights that
should be off are on, an intruder may be inside or another emergency may
have occurred. Leave immediately and call for help.
Warning
¾ Subdisarm Your System
1. Enter your Master Access Code while the system is disarmed.
Panel announces, System disarmed. Disarm button light blinks and the system is sub-
disarmed. When you've finished accessing the protected areas, press the Disarm button
again. Panel announces, System disarmed. Disarm button light stops blinking. System
is in Disarm mode.
If You Never Leave After Arming
Your panel can be programmed to recognize that you never left the premises. If you
press the Arm Doors & Windows button and the Arm Motion Sensors button but
Simon Security System