Table of Contents
Advertisement
4
Defining the KDS-EN2T and KDS-EN2R
This section defines the KDS-EN2T HDMI to IP Transmitter (see
KDS-EN2R (see
EN2T and KDS-EN2R.
4.1
The KDS-EN2T HDMI to IP Transmitter
Figure 1
Figure 1: KDS-EN2T HDMI to IP Transmitter
#
Feature
1
ON LED
2
LINK LED
3
DATA LED
4
MODE Button
5
GROUP ID DIP-switches
6
5VDC Output BNC Connector
7
LAN RJ-45 Connector
8
HDMI IN Connector
9
RS-232 9-pin D-sub Connector
6
Section
4.2
defines the KDS-EN2T:
KDS-EN2T, KDS-EN2R - Defining the KDS-EN2T and KDS-EN2R
).
Section
4.3
defines the underside of both the KDS-
Function
Lights green when the power is ON and the system is
active
Blinks when the power is ON and the system is booting
Lights green to indicate that a link is established
Lights green when system is active
Blinks when connecting to the receiver or if the HDMI
source is disconnected
Press the button using a small screwdriver (see
Section 4.3
)
Set the group ID (see
+5V DC connector for powering the unit
Connects to the LAN RJ-45 connector on the
KDS-EN2R directly or via an Ethernet switch
Connects to an HDMI source
Connects to an RS-232 port
Section
Section 4.4
)
4.1) and
Advertisement
Table of Contents
