Table of Contents
Advertisement
Setup
Gobo
Replacement
DMX Linking
DMX Modes
Master/Slave
Connectivity
-8-
Make sure to disconnect the fixture's power cord before replacing the gobo.
1) Loosen the four screws that hold the head's front cover and move it slightly
forward.
2) Unfasten the four screws that hold the head's upper cover and remove it.
3) Manually rotate the gobo wheel and pull out the desired gobo
4) Install the new rotating gobo by sliding it under the pressure plate near the center
of the wheel.
5) Reverse steps 1 and 2.
You may link any Q-Beam 260-LED fixture to a DMX controller using a standard DMX
serial connection. If using other DMX compatible fixtures with a Q-Beam 260-LED
fixture, it is possible to control them individually with a single DMX controller.
If you are not familiar with the DMX standard, or if you need information about the DMX
cables needed to link the Q-Beam 260-LED fixture to a DMX controller, you may
download the "DMX Primer" document from the CHAUVET® Web site.
The Q-Beam 260-LED uses the standard DMX data connection for its Basic and
Advanced DMX modes. You will find information about these DMX modes in the
Introduction chapter (brief description), the Operation Instructions chapter (configuration
details), and the DMX Values section (individual channel values).
The Master/Slave mode allows a Q-Beam 260-LED fixture to control one or more a Q-
Beam 260-LED fixtures without a DMX controller. The controlling fixture becomes the
"master" when running in any mode other than DMX512. The controlled fixtures are the
"slaves" and you must set them to "Slave" mode from their respective control panels.
During the Master/Slave operation, the slave fixtures will operate in unison with the
master fixture.
The master and slave fixtures link to each other using the standard DMX serial
connection. If you are not familiar with the Master/Slave connectivity, you may download
the "DMX Primer" document from the CHAUVET® Web site.
DO NOT connect a DMX controller to the fixtures operating in Master/Slave mode.
Otherwise, the signals from the DMX controller may interfere with the signals from
the master unit.
Conversely, DO NOT connect any fixture set to run as "master" to a DMX universe
because the signals from that fixture may interfere with the signals from the DMX
controller.
The Operation chapter of this manual provides detailed instructions on how to
configure the Master and Slave units.
Q-Beam 260-LED User Manual Rev. 01d
Advertisement
Table of Contents
