Mobile Home Installation - Pelpro Freestanding Owner's Manual

Mobile Home Installation

CAUTION: DO NOT INSTALL STOVE IN SLEEPING ROOM
THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR,
PelPro Series
Your appliance has been tested and listed for mobile home installation. It may be
installed in a mobile home as a "Free Standing Stove" or a "Hearth Stove", see detailed install and
clearance requirements in these sections as they imply there.
In addition to all previously detailed installation requirements, mobile home in-stallations
must meet the following requirements in accordance with the Manufactured Home and
Safety Standard (HUD) CFR 3280, Part 24:
Permanently bolt your stove to the floor, (A), figure 25.
Electrically ground your stove or the pedestal to the steel frame of the home. Use a number 8 gauge
copper wire, (B), figure 25, or equivalent.
The stove must have a permanent outside air source with a ¼ inch screen over the inlet.
Figure 26, (B, C & D)
For transportation all chimney/vent above the mobile home must be removed.
Chimney/PL Vent must be 3" or 4" PL Vent and must extend a minimum or 36" above the roofline
of the mobile home and must be installed using a UL / ULC listed ceiling fire stop (J), figure 26,
and rain cap (L), figure 26.
INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER.
A Floor Pad
B
Combustion Air Intake
C Fresh Air Duct
D Fresh Air Hood
E
Stove Exhaust
F Pipe Adapter
G Clean Out Tee
H
Tee Support Bracket
I Pipe
J Firestop Spacer / Ceiling Support
K Roof Flashing / Storm Collar
L Rain Cap
HEART H P AD
FLOOR
GROUND
B
WIRE
Note:
When moving your mobile home, all exterior venting must be removed. Upon completion of relocation,
all venting must be reinstalled, gas tight, and securely fastened.
18
CEILING and ROOF MUST BE MAINTAINED!
A
BOLT (S)
FRAME
Figure 25
7081-146E
L
K
J
E F
B
A
Figure 26
www.pelprostoves.com
H
G
C D