Image Alignment; Setting Image Orientation; Using Source Scan; Limiting Osd Messages - Barco CR series User Manual

5.8 Image alignment

5.9 Setting image orientation

5.10 Using source scan

5.11 Limiting OSD messages

31
For easier alignment of the projector, test images are built into the system.
To enable test images, go to the menu entry INSTALLATION > TEST IMAGE. Cycle the vari-
ous test images using the arrow keys. When a test image matching the aspect ratio of your
screen has been found, use the zoom, focus, lens shift and physical projector alignment to
match the screen.
In relation to the screen, the projector supports the following installation orientations:
• Desktop front (default)
• Ceiling front
• Desktop rear
• Ceiling rear
To set the image orientation go to menu entry INSTALLATION > IMAGE ORIENTATION
The projector can automatically scan through all the input connectors for a valid signal. If a
valid signal is found, the image will set up. This is called source scan.
Source scan is default disabled. When disabled, the projector will only search the selected in-
put connector for a valid signal. Use the keypad, remote control or any command and control
interface to change in selected input interface.
To set the source scan setting, go to menu entry INSTALLATION > SOURCE SCAN
When detecting sources and using the various features of the projector, OSD messages will
appear on the screen. Which messages that are appearing can be partially controlled by the
user. The OSD can run in these modes:
• ON. All messages, warning and information OSDs are displayed.
• OFF. No messages are shown.
• Only warnings. Only critical warning messages like temperature overheating will be shown.
Go to menu entry INSTALLATION > OSD ENABLE to control the OSD behavior.