Kramer VS-162AV User Manual page 48

5. Press and hold the TAKE button while simultaneously turning on the
POWER switch on the unit.
After a few seconds, following the initial machine identification message,
the MATRIX Display shows the following message:
6. Release the TAKE button.
The TAKE LED blinks and the MATRIX Display shows the following
message:
7. Press the TAKE button.
The MATRIX Display shows the following message:
8. Press the TAKE button again.
The MATRIX Display shows the following message:
At this stage, and at any time previously, you can cancel the operation by
pressing any button, other than the TAKE button.
9. Press the TAKE button once again.
The program starts working and the TAKE LED turns off.
The MATRIX Display shows the following message:
10. After a few seconds the FLASH memory is erased and the MATRIX
Display shows the following message:
Note: If upgrading the firmware on more than one unit, be sure to
perform the above steps, 5 to 9, on each unit before continuing.
1 Upgrading firmware resets your unit to the factory default. This includes erasing all setups
44
Flash Memory Upgrade
Please,
release key TAKE
Update program?
Please confirm < TAKE >
YOU will lose current SETUP
Confirm < TAKE >
Are you ABSOLUTELY sure?
Press TAKE to execute
ERASE flash MEMORY
Please, wait...
Ready for receiving
Start transmission from PC
1
KRAMER: SIMPLE CREATIVE TECHNOLOGY