Entering Service Mode; Exiting Service Mode - Ultra Start 25 series Owner's Manual

REMOTE VEHICLE STARTER
System Service Mode (Valet Mode)
System Service Mode will disable the remote starter. This will only effect the
remote start portion of the system. The optional lock, unlock and trunk release
features will still be operational. When the vehicle is to have any under hood or
service work done, the system must be placed into Service Mode. This feature
may also be used if a transmitter is lost, damaged or if the system malfunctions.

ENTERING SERVICE MODE

1. Turn the ignition key to the On position.
2. Press and hold the Program Button (Located on the antenna) for 5 seconds
or until the siren chirps five times.
NOTE: The LEDs on the antenna will turn on solid to confirm Service Mode.
If the
park lights will flash 3 times slowly.

EXITING SERVICE MODE

1.Turn the ignition key to the On position.
2. Press and hold the Program Button (Located on the antenna) for 5 seconds
or until the siren chirps two times.
NOTE: The LEDs on the Antenna will turn off and the remote starter functions
will be re-enabled.
ATTENTION:
TO AVOID SERIOUS INJURY
Service Mode before any under hood servicing is started. Service Mode
will prevent the vehicle from starting while the vehicle is being serviced.
It is the sole responsibility of the vehicle's owner to place the system into
Service Mode. The manufacture accepts no responsibility for accidental
starting of the vehicle while the vehicle is being serviced.
button is pressed while the system is in Service Mode the
5sec
, this remote start system must be set into
OWNER'S MANUAL
PAGE 13