Shock Sensor - Ultra Start 25 series Owner's Manual

OWNER'S MANUAL
PAGE 14

Shock Sensor

Shock Sensor Programming/Adjustment
METHOD 1:
Step1 - Press and hold the
and the park lights will flash 3 times and then the park lights will stay ON.
Step 2 - While the park lights are on strike the vehicle with the amount of force
wanted to trigger the alarm*. Strike the vehicle the same amount of
force 3 times. The siren will chirp each time the system detects impact.
Step 3 - Press and release
METHOD 2:
Step1 - Press and release the
siren will chirp and the park lights will flash 3 times and then the park
lights will stay ON.
Step 2 - While the park lights are on strike the vehicle with the amount of force
wanted to trigger the alarm*. Strike the vehicle the same amount of
force 3 times. The siren will chirp each time the system detects impact.
Step 3 - Press and release
* Strike the vehicle with the palm of the hand, be careful not to impact
the vehicle in an area that may cause damage. The most common
location for testing and setting the shock sensor is the A-pillar. The
A-pillar is the metal support that runs from the roof of the vehicle to
the hood area. Avoid hitting the windshield when programming.
Temporary Shock Sensor Bypass
1. Press and release the
2. Press and release
The system will chirp once to arm and once again to confirm
Temporary Shock Sensor Bypass.
and buttons for 3 seconds. The siren will chirp
and buttons to exit.
button five times (once every ½ second). The
and buttons to exit.
button (to arm system).
button (within 3 seconds).
REMOTE VEHICLE STARTER