Advertisement
TOOLS AND SUPPLIES REQUIRED
#2 Phillips screwdriver
Flat-tip screwdriver
Stubby Phillips screwdriver
Utility knife
Scissors
Tape measure
Isopropyl alcohol
(Isopropyl alcohol, in a 60/40 solution with water)
Ratchet
10 mm Socket
14 mm Combination wrench
Shop towel
13/16" (20 mm) Hole saw
Center punch
Eye protection (face shield, safety goggles, etc.)
Illustration of the Subwoofer Installed on the
Vehicle:
SUBWOOFER
HARNESS
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
2 of 11
3.
4.
SWITCH
5.
SUBWOOFER
4414030K
6.
AII 30529 (0509)
Remove the two screws that fasten the bottom of
the center panel.
CLIPS (6)
CENTER
PANEL
HAZARD
SWITCH
SELF-TAPPING
SCREW
Pull the center panel out toward you to release the
six clips, unplug the vehicle connector from the
hazard switch, and remove the center panel. Be
careful care not to damage the clips.
Open the dashboard pocket lid. Using a small
flat-tip screwdriver wrapped with tape, remove the
screw cover (two retaining clips and two retaining
tabs).
RETAINING TAB
CLIP
SELF-
TAPPING
SCREW
SCREW
COVER
TAPE
SMALL
FLAT-TIP
SCREWDRIVER
RETAINING TABS (2)
Remove the dashboard pocket (one self-tapping
screw, and pull out to release one clip and three
retaining tabs.) If equipped, unplug the vehicle
connector.
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
VEHICLE
CONNECTOR
DASHBOARD
POCKET
VEHICLE
CONNECTOR
(If equipped)
RETAINING
TABS (2)
2829302K
Advertisement
